 |
FTI 45mm and 30mm extrusions were used to build this single-rack cabinet. Interior rack-rails were provided for both front rear support of components. Access doors provided on the front and rear of the cabinet had locking latches for security. Clear polycarbonate panels were provided for equipment monitoring. |
 |
This cabinet was constructed using 45mm x 90mm, 45mm x 45mm and 30mm profiles. The left side of the cabinet had a light-tight area for sensor testing. The right side had a cpu storage area, pull out keyboard shelf with a monitor support shelf above. |
 |
The end user finished equipment installation and installed the pre-cut panels supplied by FramingTech. |
 |
Heavy duty electronic and equipment rack was provided in a near fully assembled form. the customer would finish equipment installation and then install the pre-cut panels and trim the we provided. Leveling casters were provided to facilitate final positioning of this cabinet that would ultimately weigh in @ 1000 lbs. |
