Ordering Information

Page 33

Material:
- Die-Cast Zinc
- Bolt:  steel
- T-nut:  zinc-plated steel

Finish
Zinc Plated

Application Info:  Commonly referred to as a “banjo”-style connector used on 1 1/2”, or 45 series profiles.  Requires a 13/16” diameter hole (milled ~5/8” deep ) thru (1) side of the extrusion 3/4” back from the end(~5/8” deep)

Works great as a method to retro-fit a frame assembly to an existing table-top.

Comes with 5/16-18 x 1 1/4” SHCS (or M8 x 30shcs) & t-nut unless otherwise specified.

Please call, fax, or email your inquiry.  Discounts will apply for large quantity purchases.

Ordering example:
UF32 = (1) banjo fitting, (1) SHCS (5/16-18), (1) t-nut fro 5/16 t-slot.

UF10(32)

Section:  2-7